xfx 7200 gs volt mod

[Kal-EL]

Any ideas where to begin?

http://www.overclockaholics.com/Kal/7900gs/

[Splave]

I'll take a look, not sure if its worth it that card is gutted to shit to save $$. if you up the volts too high it might explode rofl.

[Kal-EL]

+ side, it won't cost much, I think it was like 30 bucks or less.

[Splave]

check ohms pin5 to gnd
http://pdf1.alldatasheet.com/datasheet-pdf/view/205424/SEMTECH/SC2621STRT.html

EDIT:PIC added

[punx223]

soups... dont bench this in vista or win 7... so no vantage....


the card will artifact in vista or win 7

[FACE]

I cannot see the traces too well, but you might be able to swing a pencil mod on rx6 and get decent results... I found the mod for a 8600gt ddr2 and reduced the resistance by ~1/3 w/ a pencil and had tons of headroom after that. :thumbsup:

If you have a large enough camera that fits your hands, see if you can take a really good macro of that chip.... follow the traces, and boom, pencil mod of quickness. Wouldn't waste the soldering time on adding vr's.

[Splave]

supes you check it out yet?

there is no mem controller, your shit out of luck on that end unless you find some resistor mod :(

[Kal-EL]

Ah fruck man, I don't even know where to start or what to do. I gotta spend some quality time with some videos and shit but I figure its a cheap ass card to screw up.