[Hondacity]

i was gonna get some from mwave.....thanks for testing ...sad results...

[Neuromancer]

Originally Posted by Splave

here is 3rd boot, easiest so far dont mind the time
found out what cuts the power off when I start pi, this wasnt 1m stable until I switched it

Not bad Splave, Might I suggest running Waza though?

And whats cuts the power off when you start Spi??? I had an issue running spi on a system that was wPrime stable... I just added more juice though...

[Splave]

yeah im just running to see if its stable, no maxmem, no priority, wazza, services etc

5300 is max 32m. settings 5320 with turboV causes bsod. must boot 99.5x53 then up to 100 in windows

will try the other chip in a bit.

[Neuromancer]

Very nice. I just tried the new BIOS real quick and I can't boot 5.2 :(

Tried 52x and 51x @102.

Will try again tomorrow in the cold working up from 5 GHz.

[OC Maximus]

Originally Posted by Splave

yeah im just running to see if its stable, no maxmem, no priority, wazza, services etc

5300 is max 32m. settings 5320 with turboV causes bsod. must boot 99.5x53 then up to 100 in windows

will try the other chip in a bit.

5320 is the benchable max on my rev c chip with 100.7x53 in bios. it doesn't like 99.Xx54 at all.

Hope your #2 does better Mang!

[OC Maximus]

Tweaked rams and still need to figure out how to lower tRCD. I'm open to suggestions

[Splave]

hey neuro I just flashed and had a hell of a time getting the c6 and speedstep garbage to stick on boot lol. Finally worked itself out.

Here is chip #2, mem is still slow etc going to try higher now. Low volts is nice I guess

@ocm it wont do 9 huh?

[OC Maximus]

Originally Posted by Splave

@ocm it wont do 9 huh?

It reboots at 9 even at 3.5ghz.

[Splave]

what type of volts you using to the ram?

w0000000t x54 needed slight bump to VCCIO from stock to get past xp loading

[Hondacity]

increased vccio, vcore
decreased temps...