Well, I ran a 7 hour LN2 session today. OC'd the maching in the 6's 6.2 to 6.9 ghz but couldn't for the life of me get anything but novabench to read current speeds outside of 1.5ghz per core. Here is a print screen. I'm at the house now so I can run as meny sessions as I need. The only thing I can think of is, I used the jumper and LN2 switch on the Formula Z board. Should I not be using the jumper/switch? As far as I know I disabled all power management settings in the BIOS and followed all tutorials to a T. BTW I ran at -186 for 7 hours, no ice in the case. As you can see on one of the programs, the MOBO temp was around -10C from the purge nitrogen. Also the video card, which normally runs about 50C ran at 0C from the sub ambient purge. My son will be gaming with Dying Light for three hours OC'd at 6.9 ghz and -186 tomorrow. We'll be making video of the fun. See the PS below and any suggestion are TOTALLY WELCOME!
http://cdn.overclock.net/a/a1/a177d5f2_Untitled.png
ln2dad.JPG