Whn I had this unit I thought hard about how to set it up. Now I know Kal is very good with chillers so I know he can figure out how to set this baby up
One thread I looked at a lot was this one, about Liquid Frostbyte on XS.
http://www.xtremesystems.org/forums/...ad.php?t=37379
I think that this maybe the way to go.
Another option that I was told was to just use a regular water cooling setup but with a bigger rez and no Rads. Insulate up as you feel it should be.
When I contracted Jin about this unit I told him it was going to be for GPUs on my main rig. So in an after thought the temps might not get really low but it should be able to hold a good hot load at maybe -10c on the GPU/NB and use a normal large rez. Remember the CPEV will alow you to adjust the coolent temps some what.
The power of this unit might just work out for a setup like that.
Jin built this to hold 500watts at -10c so it might not be tuned for max cold, but rather max load. That might turn out to be a good thing also, so it's doesn't freeze up the HX if flow is to slow.
It is the very same compressor and condenser that is used in the SS Phase unit he built for me.
For a benching setup my thoughts were to turn the CPEV to max cold and use a large tank rez sitting on the floor to hold max temps longer. I would think you would need 2 pumps for that, one for the chiller/rez and the other from rez/GPU's.
I have seen several different mix's of coolent used for these setups. I was trying to find that info but for some reason my brain is dead today and I cannot find that info. I will keep looking and post back what I find.
Kal has used chillers before so I think he can do a great job on getting this setup
acebook
Anybody remember Pearl Harbor? Or Tiny Bubbles? Tell that USPS guy next time he's in Hawaii....."Watch out Haole!!" 
Thx buckeye, gs.
Linear Mode
