[RomDominance]

Ya Patch's last MSI GD80 was a vaseline job and lasted less than a week if I recall correctly. More to the point HC I was at stock and at ambient,...insulation had nothing to do with it.

[DOM]

What is this and do i need it ?

[DrNip]

https://www.labrepco.com/store.php?p...182&searchfor=

I have heard from peeps that they don't prefer those. You could prolly sell that hose assembly and opt for a copper tube instead.

[DOM]

Originally Posted by DrNip

https://www.labrepco.com/store.php?p...182&searchfor=

I have heard from peeps that they don't prefer those. You could prolly sell that hose assembly and opt for a copper tube instead.

Sell on ebay ? Where do you get a copper tube from ? Hardware store

IDK nothing about dewars and bever sold anything on ebay

[DrNip]

It doesn't have to be copper necessarily. Just take the fitting off and go to the hardware store and construct you something like this.



Or just keep the hose and take the separator off of it. Either or. I was just trying to recoup some of your money for you by telling you to sell the hose assembly on ebay for $100 or so.

[Chuchnit]

Dom just put your big girl panties on and tip it.

[DrNip]

That is another option. Sell the whole top for $300-400 on ebay and just tip it! New they run you around $500 or so without the hose.

https://www.labrepco.com/store.php?p...182&searchfor=

Just the hose is $200 something new.

https://www.labrepco.com/store.php?p...182&searchfor=

Then buy you a new cap for it.

https://www.labrepco.com/store.php?p...182&searchfor=

The one time I used LN2 I preferred tipping it over the withdrawal device. ROFL

[DOM]

Originally Posted by Chuchnit

Dom just put your big girl panties on and tip it.

Thats was the plan but this one came with the top

Originally Posted by DrNip

That is another option. Sell the whole top for $300-400 on ebay and just tip it! New they run you around $500 or so without the hose.

https://www.labrepco.com/store.php?p...182&searchfor=

Just the hose is $200 something new.

https://www.labrepco.com/store.php?p...182&searchfor=

Then buy you a new cap for it.

https://www.labrepco.com/store.php?p...182&searchfor=

The one time I used LN2 I preferred tipping it over the withdrawal device. ROFL

That seems like a good plan

But ill try it first see how it goes should have the F1EE monday

Need to make some room in the garage to setup the rig, my 2yr old was already messing with the valves and was acting like the was drinking out of the side you put in the ln2

[Splave]

I use a small peice of braided rubber tubing, .50c 1/2 ID 6 inches long wrapped in 2 layers of duct tape. Any peice of metal that you use will use ln2 to get down to the temperature of the ln2 every drop counts

[DOM]

Originally Posted by Splave

I use a small peice of braided rubber tubing, .50c 1/2 ID 6 inches long wrapped in 2 layers of duct tape. Any peice of metal that you use will use ln2 to get down to the temperature of the ln2 every drop counts

so im wasting some with even the steel braided hose ?

duct tape works on anything lol