[PhIlLy ChEeSe]

OK guys need some suggestions here, I have the asus RIVE 2011 and Intel 3930K CPU with two 60GB Intel Cherryville SSD'S in a raid 0, with two 7970's and a corsair AX1200PSU and finally 16 GB of 1866 RipjawX memory.

Kinda a long story as I'm not sure what my problem is here, started off I had over clocked the memory with a preset in the bios of the RIVE board. After a while I noticed I was having issue's (BSOD) and upon reboot I realized the memory was under volted while runnig at over 2400 MHz. From this point on the memory was an issue so I would just run it at default with normal voltage, and it seemed OK.
So one day I decided the memory is covered so i'll warranty it witch Gskill did no issues, while my memory was gone I had a pair of cheap ass ram i got with a PSU purchase from egg heads. Its an 8 GB kit of Vulcan 1600 memory, so only two sticks in the RIVE. I read the manual on witch slots to use, install and rebooted to adjust the settings everything was fine. Then I thought this is free memory so I cranked it up to around 1866 and upped the voltage and boom I lost the boot sector on my raid. So I killed the power and removed the cheap memory thinking ill be ok when the new Gksills get here. Upon return i installed and still no boot sector, so ok i got to lose what was on them. I deleted the raid then rebuilt it, and now it wont see my damm CD drive so I can install the drivers for a raid?
Did I kill the memory controller on the CPU, or the board, the memory is brand new so I assume it is ok. I was thinking of re seating my CPU then in bios set the defaults n see what happens..............

Suggestions

cleared CMOS no changes tried switching the Intel SSD'S to the other controller, cant see the damn CD player? ugh!!!!!! HELP!!!