Way to go kiki!! Way to grind those last mhz out.

seems like i am approaching the max clock it's going to get on dice...
it's not cold enough i think - when i just put dice in it and let it sit there for like a few min and then turn it on it'll hit higher clock...

i just looking at the validation and seems like the voltage is way lower than what i sat at
http://valid.canardpc.com/cache/screenshot/1455359.png
in my bios it's saying i put it at 1.85v but in the monitor page and cpu-z it's only showing 1.752v

anyone know why it's doing that at all?

most mb when reaching the higher volts you get less then what you set unless you hard mod them

like my pb5 deluxe is like that on the max is like 1.75 and only goes shows 1.65 but since i hard modded it it shows 1.75 and i give it more on the vr

but whats the max vcore on your mb in the bios ?

Not to sound like a n00b, but have you tried dropping CPU multi to see if it was the chip?

Oh yeah DOM is right too if your board does not have LLC.
Some boards on 775 had as much trouble with vDrop as vDroop if I remember correctly.

yeah Intel P965 didnt come with LLC :laughing:

i max out at 1.850V
i have to hard mod my baby for it to be a 2.0v board ...

how do i get it to LLC what ever

i'll do WHAT EVER it takes to get 8GHz

You need LN2 if you want more.

:laughing:
OLL RIGHT!

i monna see how my next week school schedule is..
if its not too busy i monna run down and do a session there on the spot :thumbsup:

real quick question...
should i or should i not just leave my pot mounted?
cuz it's so heavy and is that going to damage the board if i just leave it mounted?
cuz i really tight the screws REALLY tight!