Overclockaholics Forums

Overclockaholics Forums (http://www.overclockaholics.com/forums/index.php)
-   ATI (http://www.overclockaholics.com/forums/forumdisplay.php?f=42)
-   -   Lightning Strikes (http://www.overclockaholics.com/forums/showthread.php?t=2097)

Jor-El 03-17-2010 10:15 AM

Quote:

Originally Posted by Splave (Post 31604)
nope, did look like a toddler packed it though. All the tabs were ripped up


:ohcrap: so I was the lucky one to get a open-box fubar board from the store (although I bought a new one) :thumbdown:


Well I guess RMA is on the way.

Splave 03-17-2010 11:12 AM

Good news = this thread needs more of it lol

Chuchnit 03-17-2010 11:15 AM

Quote:

Originally Posted by Splave (Post 31609)
Good news = this thread needs more of it lol

LOL, well when your GT gets here fill this baby up. :thumbsup: I hope you get a killer chip.

Dentlord 03-17-2010 12:23 PM

3 Attachment(s)
Gettin ready to see what she will do!

Jor-El 03-17-2010 12:32 PM

^ Looking good!

was it easy to take the mem sink?

wish you luck like splave said we need good news in this thread.

GFDuke 03-17-2010 12:41 PM

Quote:

Originally Posted by Splave (Post 31609)
Good news = this thread needs more of it lol

You're not gonna get any from me. So far its a POS!!! I cant even get close to 1000 on air. My vanilla one did 1k on air without breaking a sweat.

Dentlord 03-17-2010 12:55 PM

No ram sink, that ram next to the pot is gonna be so freakin cold anyway lol

Crossing my fingers, gonna fire it up after I eat a bite. Hope I have enough ln2 left to go for a decent time :S

Jor-El 03-17-2010 12:59 PM

Quote:

Originally Posted by Dentlord (Post 31622)
No ram sink, that ram next to the pot is gonna be so freakin cold anyway lol

Crossing my fingers, gonna fire it up after I eat a bite. Hope I have enough ln2 left to go for a decent time :S

No Bud I'm talking about this big fat aluminum one that's stock with the card:

http://www.overclockaholics.com/foru...1&d=1268627886

Was it easy to remove?

GFDuke 03-17-2010 01:18 PM

Every Driver i try to install fails. Whats up with that? ATI

I'm with Jor. It dosnt seem like its taking the voltage. Unfortunately my mm needs batts. So i can't check it atm. Using the OSD in the bench shows that the voltage is stock. Which i believe. I lock right up in 06 at 1000mhz on 1.35. I tried going up as far as 1.45. Nothing. The temps are in range as far as i can see but it could be spiking so quick that the software dosn't have time to read and display it before it freezes up. But honestly i doubt that. Pretty sure we need a hard mod. OC? Is it in the same spot?

Dentlord 03-17-2010 01:42 PM

1300 so far is ok, cross your fingers!


All times are GMT -10. The time now is 02:50 PM.


Copyright ©2009 Overclockaholics.com