idk if theres other here idk how to look for them but i think there is but airgas didnt rent out tanks also damn mofos said it was also the same even if i had a bigger tank

I took my dremel to the top and gutted the middle, except the red lever, cleaned up the hole, and now it pours a nice predictable, strong, straight stream. It could leak out the lever hole if you tip it upside down way too far. It works awesome. :cool3: Check it out.

There has gotta be other welding supply places around. There is 3 around here...1 local, Airgas, and Haun...and I live 40-50 miles from anywhere major....and by major I mean small cities.

thats what i did but with a box cutter i dont have a dermel but cut my leg when doing it i stll got the mark lol

oh thats what there called i was looking for ln2 places

:ohcrap:lol x2....try Lubbock Welding Supply...that was all I could really find.

EDIT: I butchered it with the dremel, no tools for really cutting plastic....fortunately it didn't need to look pretty.

I totally butchered the crap outa mine, unusable now, hehe :)

Perhaps a little tutorial is in order here?:laughing:....wait, is that a hole in your leg?;)

EDIT: picture added

I should have used a hole-saw.:blush:

Having nothing but problems here this time. Thermometer stops at -110 and I don't know what the damn problem is. LEDS indicate DRAM.............. Got it going with 1 in the last slot.....think frost built up in the 1st DIMM slot with the stick in there, but that didn't happen last time. I don't even know what the frack I'm doing about some of this I just realized......lol.....I learn well the hard way. It seemed so easy the first time....beginners luck?
Time to take a step back for a few.:band2:(yes of course it's Jerry :D)

I had the same problem with my temp gauge except it stopped at -130. It was like trying to see in the dark and sucked. Ended up ruining my last session.

Watch the language bro, PG-13 forum here. I ninja edited your post for ya. :Hi:

I ran the 1090T w/ LN2 the other day with no problems and the same thermometer. Now I can't get it to OC at all with 1 in the last slot.....gotta mess with it for awhile.

My bad, thanks. :Hi:

EDIT: 1st slot works again:) EDIT: Dual Channel works too, then I poured a bunch of LN2 while in bios and it froze up and now acts same DRAM.

Every time I think I've got it straightened out it freezes up again. I don't know...either this 1090 , or my memory or who knows what. Guess I should try another CPU. It's all work now.:eek:...yup now according to the board the cpu is bad....gonna pop the 965 in there.

EDIT: everything works fine with the 965.......what a waste of time and resources. I'm going to bed because I have a bad seat on the 965 because I was too lazy to warm the pot up and put good TIM in there when I switched cpus. I'll remount it in the morning and use up this juice....what I didn't waste. My eyes are beat and I'm already partially soured o the experience for now.

Happy New Years anyways. Tomorrow will be a better day at least with the 965. Wonder what the problem with the 1090T is....I've been using it.