how long has this build been going on for ?

thats why i dont like cases to much work to get it to the way you want it :P

but when it's finished, i makes the trouble wourth

untill you wanna upgrade it :laughing:

but it looks very nice alot of work put into it :good:

for a 24/7 rig, this will do i think lol

1/4" fittings? For....

Likely another chilled loop? no?

I was thinking a HDD cooler, but the HDDs are not located anywhere near there are they? (unless thats the only spot left for another pump lol)

it for an extra bottom plate in the case, and under it, will come in the loop :

inline temp sensor,
flow sensor,
pump PMP-400 or PMP-450,
drain valve,
koolanc TMS-200 controller,

and maybe if i have enough place left (height of 4,1cm) i put also a thin fan in there that blows up to the GPU'S.

the bottom is as good as finished,
just need to order a flat pump with top...
if a Koolanc PMP-400 pump with top is maximum 40mm heigh.
I can take the bottom out any time it's a tight fit and is on 2 alu plates, nice and steady.
The usb internal, sata and ECP connector on the mobo is nice clean now.

This is no metal plate but 4mm not shiny black acryl plate PMMA15

only needs to get connectors for the PciE powercables for the GPU's :

http://i52.tinypic.com/2cqmcfd.jpg
http://i55.tinypic.com/1okm55.jpg
http://i52.tinypic.com/znadeg.jpg

Nearly any pump will do with the Boreas...I have seen little effect between pumps with the units. Same goes with the waterblock...stock vs aftermarket.