Nice thread I wish I had your biblical Job patience!

man, if its working then its amazing, moreso because even if something goes wrong, I think its an experiment certainly worth trying(ofcourse only for Top 50 guyz I suppose), :good:

getting a little better at the board
http://valid.canardpc.com/show_oc.php?id=1246372

Just need to get 1:2 mem strap to work. I kicked OCP in at 2.1v lol oops

Voltage over 2v on a CPU always makes me smile.

haha for sure, any trick to getting 1:2 to work mr.patch? some prociess just dont like it?
Im using the outer most ram slot. 1gb cellshock

That's quite expensive binning technique :D

Actually cedarmills are scaling quite linear. So there is no reason to waste LN2 for every single cedarmill sample. When I and Sam were binning cedar mills first thing to do was just simple air testing with 1.45V if you can't reach 5Ghz here you better step to next sample :D If cpu reach 5Ghz+ then it's qualified for next stage under DI- we are aiming here for 6.4Ghz at least, not much CPUs will be able to do this but if it can then congratulations you have 7.5Ghz+ candidate under LN2 ;)

cool technique :) I like it. DICE is more expensive than ln2 for me though! I love your 8ghz run man, very nice.

I finally got a decent one

http://hwbot.org/community/submissio...52_7559.95_mhz

347s are the way to go huh?

than it's different story :) here in banana republic it's quite expensive & I have to rent dewar :(

any cedar mill can be good- I know there are some batch theories but I never got into them
But in general from my own experience and results seen:
Costa rica I would say mostly sucks but with very rare exceptions
Malay has some rare samples really good
China has best luck to get good sample ;)

always the chinese

Nice man I want those 32 points!!!

Congrats!