Overclockaholics Forums
Page 2 of 3 1 2 3
Show 40 post(s) from this thread on one page

Overclockaholics Forums (http://www.overclockaholics.com/forums/index.php)
-   Volt Mod's (http://www.overclockaholics.com/forums/forumdisplay.php?f=85)
-   -   Deanzo's Volt Mods (http://www.overclockaholics.com/forums/showthread.php?t=702)

Deanzo 06-28-2009 11:48 PM
Quote:
Originally Posted by 2chesapeakes (Post 6870)
What is the wattage of the soldering iron you use for the mods and do you have a close up of the GTX 280's and 4870X2's so I can see where all the connection points are. Also what is the value of the VR's for each card
Thanks
The little soldering iron I take everywhere is only 8W, get's hot though and has a great tip for doing small mods.
VR's are 100 OHM's
Yes I do have close up shots, I'll dig them out for you.

Chuchnit 06-29-2009 01:36 AM
Very nice guide Deanzo. Your VGA mods are very clean too.

Vivi 06-29-2009 02:37 AM
Yo deanzo welcome to the forum and thanks for sharing!

I dont think these guys will have problems modding anymore :D

Kal-EL 06-29-2009 02:40 AM
Oh but I'll lotsa quoobtions when I start the first one :ash1:

Deanzo 06-29-2009 02:51 AM
Quote:
Originally Posted by Chuchnit (Post 6885)
Very nice guide Deanzo. Your VGA mods are very clean too.
Thanks man.

Quote:
Originally Posted by Vivi (Post 6900)
Yo deanzo welcome to the forum and thanks for sharing!

I dont think these guys will have problems modding anymore :D
Hey bro :)

Thanks mate, lets hope so.

limpkorn 06-29-2009 08:49 AM
Very awesome dude! Thanks so much for so much great info!

Deanzo 06-29-2009 09:44 AM
Quote:
Originally Posted by limpkorn (Post 6988)
very awesome dude! Thanks so much for so much great info!
np :)

karmakazi 06-29-2009 09:49 AM
Nice guide deanzo, you do nice work for "jumping right in" :D

Deanzo 06-29-2009 12:03 PM
Quote:
Originally Posted by karmakazi (Post 6995)
Nice guide deanzo, you do nice work for "jumping right in" :D
Thanks mate.

crio 06-29-2009 01:12 PM
Great work man.Really clean.Wish my mods where like that always.
Keep up the good work


All times are GMT -10. The time now is 03:51 PM.
Page 2 of 3 1 2 3
Show 40 post(s) from this thread on one page


Copyright ©2009 Overclockaholics.com