|
Its temp of the cores based on coretemp im using for temperatures
|
Have you tried running the CPU at stock clocks and running the memory at the desired settings?
|
Yes i have no problem at all at cpu stock settings and memory on xmp 2000mhz
|
At what clocks do the problems start. You may need to slowly bump up the OC on your CPU and see when the problems start to occur.
|
A small Update after playing with bios
23x 187 bclk 1.318 vcore and my memory at 1864mhz 8-8-8-24 2t 1.65v 1.60qpi After 10 run at intel burn and everything seems stable no bsod and also 30min at prime32 |
Problem in setting the 12G Dominator CMG6GX3M3A2000C8 to 2000mHZ
Hi everyone,
Using the ET6 i manage to OC my CPU easily at 4.16GHz, but with the ram at 1600mHz only. Can anyone help me to crack this problem, as im a newbie to OC........... :Dizzy: Intel Core i7 975 Extreme Edition 3.3GHz|Cooler Master V10 processor cooler|Gigabytes GA-X58A-UD7|Cosair Dominator GT 12GB DDR3-1333 8-8-8-24|PowerColor 5970 2GB|Creative X-Fi Titanium-Fatal1ty|Seagate Barracuda XT 2TBx2|Thermaltake Tough Power series 1500W|Coolermaster Cosmo S 1000| |
don't use XMP, but set the ram as specs manual.
also put the specs of timing manual in bios and voltage to 1.66v. Then maybe only need to adjust the QPI/VTT voltage for stability as how hard you're uncore goes. Normally QPI volt is somewhere between 1.3 to 1.4 , maybe 1.45v max if you don't OC to much |
what happens when you increase the ram or CPU speed? Any difference if you only use one stick of RAM at a time? Try one stick in each DIMM slot to rule out mobo issues. Could be an IMC issue too, do you have another chip you could swap in?
|
| All times are GMT -10. The time now is 01:40 AM. |
Copyright ©2009 Overclockaholics.com