Roger that ... Gunner has the new rev 2 Koolance and D has a rev 1 and a Koolance GPU pot .... I will be getting Tek 6.6 very soon

Hopeing in time to be competetive for the tech station contest ....

so we have some pots to roll with

But you are good to go...... bottom line everyday of the week flip a switch for Sub Zero is hard to beat.

Me personally will never be with out one again as they make abusing 3D almost too easy ...... and do respectable at 2D , that is my single stager anyhow ......


I still want a pot for some 2D action though ......

I should have my 30L by then.

Another update from da Gunner on the SS

Looks like my dumb ass had a leak and now losing charge.

Simple enough fix and actually is the best case problem there could have been.

A bum compressor or contamination would have been worse ....

looks like I will have to brush up on my skillz a bit for the next one......

But it is in good hands as Gun is very thourough and will test this beast under exstreme circumstances before sending it out to D ..........

I feel pretty bad now that the hold up is all my fault but I did my best on it.

D will get a wicked SS as preliminary tests have this thing running colder than mine, maintaining it under load. I think this is where the 1.25 rotary comes into play...

I will post more results as they come in from gun ............

D = Dentlord?