Same problems with different ram tho Honda. I have not taken any measurements on the psu...it is the same PC Power & Cooling 1200 I have had forever.

980x with 1.528v is too much for air/water .....instant degrade...

during bootup....psu isn't stressed much....with aircooling settings..

nice you have good sticks, thats not too much volts for ram :) if its doing the same thing with different chips and boards it must to be the chips or boards :thumbsup: psu and ram are the only possibilities really.

you are using to much vcore for the 980x though stay under 1.5v unless you start tossing icecubes in

I am so stupid! :argh: It has been the psu all along...plugged in the Antec and she took off like a rocket. Here is a follow up run to show the first wasnt a fluke. :thumbsup:

Me so horny that 980X lives! :rofl

good thing i never bought that turbocool1200...fukcing expensive and ocz doesn't have money for rma'ing that..lol

i suggest antec hcp1200 :D

Looks like Rick is rolling hot and it will take a 980X to beat his 980X in SPI. I think I might can squeeze some PiFast passt him (had a low 18.6ties) but no fucking way I can do better than his 980X. :Dizzy: Pretty sad! :ohcrap:

i been trying cut down the speed but nothing...
i just can't get this sub 1.40 on super pi 8m at all!

idk why even i lowered the timing it's still high?
would it just maybe the timing is too low?

Man I havn't even got my XP partition installed yet ..... :shock:

FACE?
i was just looking on the FTP and then i just saw the MRI 5.1.1 where did you get that from?
http://www.overclockingalliance.com/...RI5.1.1.ISO.7z

are you doing wazza?