I'm using a pot because i've already my board insulated and was to bored to take the pot off.As crio mentioned i had to put wc to my nb so as to run 1800@6-6-6-16 pl8...

You kill me man.....
Who got you that board???:taunt::rofl

any board can do pl8 once the cas is on 6 ;)

It's the one you had ordered for me buddy!!!:thumbsup:

That crappy one booting 640-650FSB?

ok confirmed.

The guy over at our lowclock would get 92000 on single 4890 if he got 1200 nature. very strange

he keeps getting 1177 car low.

He's using some 8.6 driver he said came with card, dont know why its working on a 4890, will check it! He is legit tho :? so i will see whats up..

Really? I'm running PL8 960mhz 7-6-6-18 1t with the shitty waterblock on the nb still on air. Yet my board hates anything other than 333 strap 5:8 divider.

8.6 are early alpha drivers supplied to the channel partners of ATI for the release of the 4890, they work well i must say, but can be buggy at times.

yea but this guy is getting constant 1177 car lows :?.

i just finished my first session with single card and if i could get 1200 nature i too would be hitting 92000...pretty much on the nose, if i could get 1200 nature :argh:

single GTX260 is running out of gas much over 1000MHz at 1.25v and any higher in volts gets me a pretty little screen full of pixelated colors...AKA OCP. i might have to really dial down the OCP mod. i didn't have leads connected to the mod and a couple blind turns didn't gain anything so i played on the side of caution and just took what i could. next session i will mess with OCP a little more. here are a couple photos from this afternoon...

http://3oh6photos.com/forum_post/oca/09_07/_MG_3040.jpg

http://3oh6photos.com/forum_post/oca/09_07/_MG_3036.jpg

the good news is this card has no problem benching at -135C, hung around -120C most of the session as colder didn't help much but -140C through Nature wasn't a problem, no special BIOS, just whatever came on the card :thumbsup: