I need to get hold of a good mobo to see what my QX9770 will do. Tried it a quickie on the Rampage Extreme, screened at 5.7GHz+ with an old mousepot. :)

heehe, i didnt have it for along time,, just got from intel and only a few ln2 runs and return back :laughing: ... and never tried on 2 or 1 core :P

I respect your ability to return such a chip, I weaker man woulda have "Lost" it :laughing:

So true! :rofl

heheh :) it wasnt that good on 4core stability,, only 5.6ghz 3d06 :)

:dance::band1::band2:

Woot my lazy ass hooked the REX back up and my 5705mhz was validated! Woot all time best and this was done with a pitiful mount :(

http://valid.canardpc.com/cache/banner/600007.png
http://www.overclockaholics.com/foru...1&d=1247022434

Not bad at all, but I reckon you can do a little better than that. Run at the 400MHz NB strap and the lowest frequency RAM you can run, if your board is any good, you'll fly past 650MHz FSB. ;)

The one I had for the MOA qualifiers did 685MHz or thereabouts with my E8600 (on a lower multi, unfortunately), but there's of course no validation of that. :P

Well I'm sure I can. For some reason bios 0901 that I was running only likes the 333 strap 5:8 divider??? Most other straps I can't even boot no matter what I try. My mount sucked that session and I just spent about 20 minutes to get that. Maybe I'll bench this setup again sub-zero.

CPU: Xeon W3540 cooled by F1 EE and DICE 5.23Ghz
MB: X58 Classified 759
RAM: Dom GT's

http://valid.canardpc.com/show_oc.php?id=577385
http://i36.photobucket.com/albums/e1...23GHzW3540.jpg

Got to love that REX!