xfx 7200 gs volt mod
 

Any ideas where to begin?

http://www.overclockaholics.com/Kal/7900gs/

I'll take a look, not sure if its worth it that card is gutted to shit to save $$. if you up the volts too high it might explode rofl.

+ side, it won't cost much, I think it was like 30 bucks or less.

check ohms pin5 to gnd
http://pdf1.alldatasheet.com/datashe...C2621STRT.html

EDIT:PIC added

soups... dont bench this in vista or win 7... so no vantage....


the card will artifact in vista or win 7

I cannot see the traces too well, but you might be able to swing a pencil mod on rx6 and get decent results... I found the mod for a 8600gt ddr2 and reduced the resistance by ~1/3 w/ a pencil and had tons of headroom after that. :thumbsup:

If you have a large enough camera that fits your hands, see if you can take a really good macro of that chip.... follow the traces, and boom, pencil mod of quickness. Wouldn't waste the soldering time on adding vr's.

supes you check it out yet?

there is no mem controller, your shit out of luck on that end unless you find some resistor mod :(

Ah fruck man, I don't even know where to start or what to do. I gotta spend some quality time with some videos and shit but I figure its a cheap ass card to screw up.