[DrNip]

Well I buckled down today and started gettin my tech station ready for action this week. I finally got around to screwing down my psu and zip tied all the extra cables down out of the way. That was a task in its own. I also put velcro strips on my fan controller and the station to hold the controller down in place. And finally I got rid of the one fan on the station and squeezed two fans in its place. That way air is being blown across the whole board and not just down the middle like it was doing. I used my SilenX fans as they blow alot of air at a pretty quiet db. They just weren't that good on a rad but in open air they are. The fans turned out easier than what I thought they would be. I just had to turn the brackets around to the middle and use three small zip ties. Now I will get air blowing directly across the RAM, NB and mosfets.

BEFORE


AFTER