Leak tested for about an hour. Rad is in the window without the fans blowing yet.
Decided to boot her up and...
F3-F6 post codes is all I can get (slight Flash on the reset button after F6) rinse and repeat thrice then it powers down for 4 seconds.
If I reset CMOS it powers up with F3 code shuts off. Then goes back to F3-F6 post codes.
If I pull all the ram and the video card.. same thing, so it is not even getting to a point of initializing IRQ I assume.
going to try swapping out the PSU for my fortron and see if that works (doubtful:( )
EDIT: okay it did work until I hooked it all up :s now that does not work either.. I had all peripherals removed all ready so it isnt them....
__________________
"Don't You understand? This is Greek to me! Except I spek Greek, this is like Aramaic to me, and not the Western Dialect I can read a little." - Dr. Walter Bishop
Special relativity is not "Eat Two Big Macs."
Last edited by Neuromancer; 11-07-2009 at 02:24 PM.
|