Thread: More water cooling questions.
View Single Post
  #9  
Old 11-07-2009
Neuromancer's Avatar
Neuromancer Neuromancer is offline
OCA Gladiator
  
Join Date: Jun 2009
Location: South Jersey, USA
Posts: 5,645
Rep Power: 23
Neuromancer might just be on to something hereNeuromancer might just be on to something here
Default
Leak tested for about an hour. Rad is in the window without the fans blowing yet.

Decided to boot her up and...


F3-F6 post codes is all I can get (slight Flash on the reset button after F6) rinse and repeat thrice then it powers down for 4 seconds.

If I reset CMOS it powers up with F3 code shuts off. Then goes back to F3-F6 post codes.

If I pull all the ram and the video card.. same thing, so it is not even getting to a point of initializing IRQ I assume.

going to try swapping out the PSU for my fortron and see if that works (doubtful:( )

EDIT: okay it did work until I hooked it all up :s now that does not work either.. I had all peripherals removed all ready so it isnt them....
__________________
"Don't You understand? This is Greek to me! Except I spek Greek, this is like Aramaic to me, and not the Western Dialect I can read a little." - Dr. Walter Bishop

Special relativity is not "Eat Two Big Macs."
Last edited by Neuromancer; 11-07-2009 at 02:24 PM.
Reply With Quote