I was also thinking that the middle piece is there for support. I think that maybe the middle could be a slot about 100-150mm. Then a solid support point at each end of the middle hole and then some 100 - 150mm slots on each side of that. Are there any boards that would need slots on the arch left and right sides? The slots on the side of the tray just need to be longer so the arch can have more movement.
This is a rough drawing but i think this design would work out.
__________________
DUKES PC MODING PAGE
Ferengi rule of acquisition #8: " Small print leads to large risk. "
Last edited by GFDuke; 02-18-2010 at 10:31 AM.
|