Thanks Bill. So far so good.... idle Temps are at -41 and load is expected to stay around -38 to -40 with the probe mounted better.
I might just take the long way around bleeding it and touch the valve for 1/2 second and test until I hit the balance of superpi and wprime temps...
This way I will not have to worry about letting too much out.
Just as I type that, I realize that I left the insulation pulled back from the compressor end of the suction line... DOH.... I'll have to let it warm up and tape her up again... looks like gpu testing is taking a back seat for today. Unless I miraculously hit the magic load temps in a few hours....
