Finally got my fatboy insulated and mounted to the card
It's sitting in the slot but I can't run it yet cause I can't find my vaseline
Ended up wrapping the entire pot with blue tape, then armalex (cut outs for the fittings etc), then a sheet of frost king all the way around too
That did a pretty good job of eating up most of the gap but I erasered the fitting around the copper block then stuffed eraser into the sides and bottom and top after mounting the pot to the card.
Used 13 copper moffset blocks, 6 black aluminum chip sinks, and 7 low profile memory chip sinks.
Looks pretty bad ass
As soon as I can find a black Sharpie so I can write MD on it I'll take a pic
added: I broke my favorite insulating tool right at the end
my wooden chopstick snapped right in half dammit