OK....so far so good. No leaks, no moisture. Still no thermometer on the chip though.
Software says 7c right now, and has been as low as 4c. I think I may be getting near the gelling point of the coolant because it went up 2-3 degrees....after I ran through 3dmark06 @ 4.5GHz/1.55v
..............the 1055t wouldn't do that @ 1.6v. I just guessed that 1.55v might do it. I'm sure things will change.
I went from 3.4GHz to 4GHz to 4.5GHz...lol...I wonder if it will run IBT or anything really stressful. I'll keep you posted and get some pics up in just a few minutes.
Thanks a lot guys!! I am really happy with the results of the 2nd attempt.
This cold shit rules. No way could I run this chip @ 4.5Ghz before the chiller.
Pics added: The front(never took out the memory), the back, the eraser I removed because it was too thick, didn't stick to anything, and didn't seem to be doing anything to help matters, and the whole system in poor lighting. I'll get some better daylight pics tomorrow.