Gawd! What a wad! All I like now is the hdd, ssd, video card and a couple of fans. After they go in I can tie up loose wires.
Rather than cut on the case any further I decided to just run the needed pci-e/molex connectors out the back for the Boreas TEC's and pump. I would like to get someone to cut me a piece of wood 12"x27" and router the edges pretty to mount all of this on. That way I can move/handle the entire set-up if needed. I could even devise an acrylic cover that would slide up to the back of the case and completely cover the cables/Boreas unit.
Just noticed the 24 pin connector had on stick of ram in a bind...taken care of.
