Thx for responses.
Quote:
Originally Posted by punx223
could be CPU as well dude.
I will test see if I experience similar when I get mine for review...
should be here in a day or few..
Can you lemme know what components your running so I can try and match it.
|
Better not be CPU. This one's nice.
SS -37 to -40 load at evap head. 2 high CFM 120X38 fans on RAM and PWM's. Smaller fan on "Southbridge" - it gets warm with higher baseclock. Velociraptor 150, Ripjaws 2X2gb 6-8-6-24/1600's @ 7-10-8-24/2260 1.74v (need 1.73v minimum to boot at c7 with 2133 divider), LG DVD player, GTX 280.
I have a lot of extra chips here and an unopened UD4 to help troubleshoot.
Quote:
Originally Posted by dRweEz
Ran into the same issue on Saturday, MIVE with 2600k @ 54*104. All the rear USB ports died but the front still worked. About 10 min later the board died completely. Clearing the bios did nothing and when powering up the board it would just power down.
Fearing condensation issues, stripped the rig down and the board went into the oven for 5min @ 80 Deg. After letting it cool down for a little while put the pot back on and everything was back to "normal" for the rest of the session.
My Rampage III Extreme after about 4 hours at -100 or more would act the same. My best guess is that some of the components get a to cold when the art eraser freezes through.
|
If that's the case, it'll be bittersweet. Was only at SS temps: -40ish at the evap head. This CPU was still scaling linearly with small voltage bumps at 5.82 ghz. I stopped at 1.645v while at SS temps and had fantasies of 5.9 when giving 1.7v at 10-20 degrees colder temps.