[PhIlLy ChEeSe]

Hey all!
I'm not to good wid reffers But I'm sure we got some here! So any way, let me know what I'll need to make a nice unit, finally got this thing out of the fridge today. I got a link to Xtreme systems so gonna, cruz back there.

[Neuromancer]

*sigh. Yet another underpowered compressor trying to cool a rig post?

I know nothing feel free

[PhIlLy ChEeSe]

Originally Posted by Neuromancer

*sigh. Yet another underpowered compressor trying to cool a rig post?

I know nothing feel free

Is it, I don't know? It came out of a freezer kept it damn cool...........

[Witchdoctor]

Igloo 52 quart cooler mod

drop the evap in cooler full of liquid that won't freeze (Glycol/water solution)

Set up condensore with fan in a place it won't cut off your hand ...........

Guards are not overated

Run poly feed to bottom and return to the top of opposing side seal all penetrations and make sure you can open it to keep full

insulate poly and hook up like standard water, you will however have to insulate the board as you will have condinsation.

Insulating will prove the be the difference in epic and fail



get the best pump you can afford as this solution will have a higher viscosity than plain water making the pump work a bit harder for a living

turn on and have some sub ambient fun

[PhIlLy ChEeSe]

Originally Posted by Witchdoctor

Igloo 52 quart cooler mod

drop the evap in cooler full of liquid that won't freeze (Glycol/water solution)

Set up condensore with fan in a place it won't cut off your hand ...........

Guards are not overated

Run poly feed to bottom and return to the top of opposing side seal all penetrations and make sure you can open it to keep full

insulate poly and hook up like standard water, you will however have to insulate the board as you will have condinsation.

Insulating will prove the be the difference in epic and fail



get the best pump you can afford as this solution will have a higher viscosity than plain water making the pump work a bit harder for a living

turn on and have some sub ambient fun

Thank you man!

This is my plan but keep in mind I'm a total noob with A/C, I have two sets of coils the one with the silver rad is closed the coil that went into the fridge rear(its an old fridge) were cut to get the unit out easier. Still took me over ten hours to remove it, I was gonna put the hoses through the side of freezer an drilled the coil yup!

So that coil first has to be repaired and closed n oiled, would you be so kind to start from there? I know i have to close the loop, wat is the best method, can i use compression fittings? I will also need to fill the unit as it all leaked out when I tried to drill it...............................................

Thank you Witch!

[Witchdoctor]

you have to braze the joints, preferably purging with nitrogen while doing so,

once the loop is repaire you have to evacuate the system and charge it with the correct refrigerant

then you can start building you chiller system

[Neuromancer]

Wut he said. Just listen to him

Sorry I was in writing mode yesterday, and had a couple of beers to boot (the two usually go hand in hand lol)

His one image said everything I did in 1 second. lol

[PhIlLy ChEeSe]

Alright small up date,

I got this thing sitting around and im never gonna finish it, anyone need a compressor let me know..........