[Assassin48]

Originally Posted by Kal-EL

Hey bro, looks tight. No condensation should get thru there. I've been seeing discussion about the eraser being having two effects on the board. One positive, one negative. One it does insulate against condensation, two it conducts heat (low temps spread thru the eraser) making the entire board very cold. Speculation is that it effects the dimm slots after a while (being too cold).

Its a bit of a cannudrum tho because, people run dice pots on the mem dimms so I'm not completely sold on the (Spreading cold idea). Just food for thought should you encounter cold bug issues.

i guess i could use a hairdryer to heat up the eraser then if i do get too cold, and the back side i added some eraser were the PCIE slots are.

As for the gpu how would i go on prepping that ?
Should i just put eraser on the whole card ?

[rickss69]

Lot of people use vasoline on the cards. Easy do/easy clean-up. I doubt your ramsinks would take much abuse prodding around with erasure.