[Jor-El]

Originally Posted by Dentlord

So is this supposed to eliminate the CBB and CB, or just lower them?

I wonder if this will do anything more on my 670/classified setup, the board already has shamino's cbb mod done ...

It's either one or the other. If you have done the cbcbb mod on the motherboard you don't need it on the cpu

[Hondacity]

Originally Posted by Jor-El

It's either one or the other. If you have done the cbcbb mod on the motherboard you don't need it on the cpu

+1

looks like its the same short.....removing the resistor out of the circuit

[Buckeye]

Yeah I need to do the mods on my board (its a Rev 1.0), but the MB mod is not easy for me, my eyes are not as good as they used to be :(

It CB's at -60c ... ouch :(

[Hondacity]

Originally Posted by Buckeye

Yeah I need to do the mods on my board (its a Rev 1.0), but the MB mod is not easy for me, my eyes are not as good as they used to be :(

It CB's at -60c ... ouch :(

cover everything with some sort of tape......so the target is isolated..and no other points/joints are exposed..conductive pen will work...just clean the surface first....a nice hard eraser...then blow / aircan your mobo...make sure the cpu is already seated..otherwise something could get into the socket...



mine eyes are bad too...but thats why i have mi spectacles...