[Dentlord]

Much better results this afternoon with the 762 ...

pifast @ 6100 and wprimes @ 5530, was just getting started when things got weird though ... evbot stopped working, could barely get it to post let alone get into windows ...

Nothing is wet, insulation is good, so Im hoping itll be ok once it thaws outl

Screenies when I can pull them off that hdd

ALSO:

CB has changed, now CB and CBB are the same ... -132

[Jor-El]

Originally Posted by Dentlord

Much better results this afternoon with the 762 ...

pifast @ 6100 and wprimes @ 5530, was just getting started when things got weird though ... evbot stopped working, could barely get it to post let alone get into windows ...

Nothing is wet, insulation is good, so Im hoping itll be ok once it thaws outl

Screenies when I can pull them off that hdd

ALSO:

CB has changed, now CB and CBB are the same ... -132

So what's the verdict: sell all 760 boards?

[Splave]

Originally Posted by Dentlord

Much better results this afternoon with the 762 ...

pifast @ 6100 and wprimes @ 5530, was just getting started when things got weird though ... evbot stopped working, could barely get it to post let alone get into windows ...

Nothing is wet, insulation is good, so Im hoping itll be ok once it thaws outl

Screenies when I can pull them off that hdd

ALSO:

CB has changed, now CB and CBB are the same ... -132

saweet! great results, x33 multi? what kinda vtt and vcore. details Set the signal options or left at 0 ?

I would check the closest ram slot to the pot maybe got a drip or something?

[Dentlord]

Originally Posted by Splave

saweet! great results, x33 multi? what kinda vtt and vcore. details Set the signal options or left at 0 ?

I would check the closest ram slot to the pot maybe got a drip or something?

33x multi yes ... ram and uncore were low, just testing the limits

vtt +300 ... it HATES any more than this, and less might be helpful (will test next time)

vcc 1.85v for 6ghz, 1.9v for 6.1ghz (2c2t, pifast and am3 ran without issue)

Wprimes would run 5530 @ 1.75v, seemed to be fine for more but when I tried to set 5600, that is when the shizz hit the fan and never recovered.

This A batch eats voltage, with the exception of vtt it scaled very well every time I bumped it until I hit the wall @ 6.1

I think Vantage and 06 @ 5.5ghz, and the other 3d at 5.9 is about what it looks like this one will do.

More testing to come.