[HybridChiller]

update :

[DOM]

NICE WORK

[HybridChiller]

small update, got at last the snake connector in, so the 3th pump can be fitted and the loop closed,
ready to fill it up.
left of the pump you see all kind of cables , that's for the Koolanc TMS-200 controller, all kinds of temp sensors all around the mobo and cpu's.

[HybridChiller]

i'm going to fill up the loop now the 3th pump is installed, own mixture : 25% Ethylene Glycol and 75% PURE water, no demi.
what you see in the measure cup is the Glycol no color pure 100% glycol :

here my koolanc poor in cup on the ZERN res with a snake connector to make it a little bit eassier to fill :

on the drain valve i putted also a tube in a bus filled with my mixture, where the pump can draw it's liquid from when i put the valve open, to make it a little bit eassier to lol :


and here comes the first liquid lol, pumps are now running to get the last micro bubbles out the loop, for now, no leaks found :

[HybridChiller]

It's a miracle !!!!
i get it closed hahahahaha, +200m cable in limited room of 3,5cm lol :

here you see that the plate is a little round, but i put the cable fast fast in to look if i get it closed,
later on the cable will be nice routed and strapped so that the plate doesn't look round :

[HybridChiller]

last minute adjustment for the vga's :

[HybridChiller]

little update :

[HybridChiller]

hahahaha, 200 Bclock at last, 10min fidling

but damn just the stupid update config when it boots pppfffff

http://valid.canardpc.com/show_oc.php?id=1711393

200 Bclock, 2002 Mhz mem, 4004Mhz Uncore, just the way i like it

[HybridChiller]

little playing around with this setup :

http://valid.canardpc.com/show_oc.php?id=1717611

4.4Ghz , 2000Mhz mem, uncore 4000

[HybridChiller]

here are the load temps, cpu temp in Coolit software is not correct, cpu isn't supported by the coolit software.
As you see idle the coolers run lower power, when stressed the coolers will raise there cooling power, and keep the liquid temp low, under Ambient,
cpu temp raises a 5 a 6°C from idle to load thanks to temp controlled coolers.
Temp of liquid is set @ 22°C max, min power of coolers @ 60%, max power @ 100%, real nice settings on these coolers,
and the coolers don't even run at 100% to keep the temp, for me that's good for lower noise level :