[K404]

Originally Posted by der8auer

That's true. I just like to build them on my own



If someone would like to make a review of this pot. Price would be a lot lower. Just sayin

I hear ya....I reckon it would be really satisfying to watch that being CNC'd

You're a bad influence... what kinda review you thinking of? Vs Otti Xtreme R4? Vince' Gemini? Petris Inflection Point?

[der8auer]

Originally Posted by K404

I hear ya....I reckon it would be really satisfying to watch that being CNC'd

You're a bad influence... what kinda review you thinking of? Vs Otti Xtreme R4? Vince' Gemini? Petris Inflection Point?

I doubt that as only about 30% is done by CNC It starts with drilling the 17 holes which takes about an hour. Then the milling cutter which you can see on the picture removes a lot of the inside.

The result is this:


Everything else, including the Aluminium Tops I'm doing by myself on a non-cnc turning lathe.


I'd just like to see how it performs compared to other Pots (especially Kingpin, Petri, Otti Pots). And it's better to have the opinion of somebody else about this BEAST.

Plus I'd just like to see a nice Container Review