[Splave]

done

[punx223]

remove IHS is really easy on IVB just remember not to dig Razor into Green PCB area of Chip.... keep it level or even point up a lil if possible.... the black is just like a rubber/silicone = easy to cut through once started the razor should just kinda glide through it nice and smooth.

[punx223]

also standard clear silicone will work fine but remember this stuff is not cement so can be cut off just like the black stuff

just dont use too much as some silicone can expand slightly and dont wanna make IHS contact worse than before...

If going for bench I would say leave IHS loose and hold on while loading so can be remove as needed.

[DOM]

Originally Posted by Splave

done

nice i was sleeping well im still half alseep ill do mine in a few hrs