Any one can throw a pot on something. That's just sooo easy. Dry Ice right at the walmart even.....
Cpu Block - Rad - Res - Pump - Chiller blocks - back to Cpu block.
Tec hot side
TEC block Rad - Rad -Rad (push pull fans) -res pump - back to tec block.
The hot side TEC blocks will get hot. To optimize heat dissipation, put fans right on those hot ass water blocks.
Expect needing negative Cpu liquid temps in order to perform 40c loads on 130w roughly. -15 to -25 ought to do it. Condensation depends on hose thickness. The thicker the better. Contain the chilled liquid will work best.
Some minor sealing around the Cpu heat sink couldn't hurt for just in case. I don't think you'll get frost on and through the board in my honest opinion. If you move enough air flow around the water block and hoses, you might not see condensation at all.
__________________
Now running i7 3770K
AsRock Z77 Extreme 4
Antec 850w CP series
Mushkin PC-14900
Running DDR3-2200
Liquid cooled GTX 480
Last edited by ShrimpBrime; 02-10-2013 at 06:55 AM.
|