[Witchdoctor]

I have Zero experience with TEC's ...........

So the biggest hurdel is learning how they work to be able to impliment action. Right now the plan is to take them off the Boreas, use two of the 4 to cool and the other two disapating the heat off the twoi cooling TEC's ... Just sandwitching them if you will to meet surface requirments, if that makes any scence at all, problem is I will cut my capacity in half and in doing so will the water heat disapation make that much of a difference gain back 100% of the performance as that would be the break even to air coupled, TBH I would be happy with that or a little better. Right now the unit does 15C better than ambient water, not sure if you saw my results table a few pages back, but here it is again if you didn't. Being I am not the sharpest knife in the drawer is there any math that can give me the answers I need based on rad surface, air speed across the rad and pump flow rates based on the output wattage of the TEC's and if so does anyone here know what the formula would look like if I could plug numbers into it ?

One thing is for sure Rich, if it works I will make it look good doing it ........