***Corsair Dominator GT Elpida Hyper Announcement *** - Page 2

hellcamino · #1 07-07-2009

Quote:

Originally Posted by Afterburner

I am at the office still I will have to check when I get home.... I can tell you with my Classy it was set manually...

I'm still curious, my board with the Mushkin ram I first tried would set the vtt to 1.585v and vdimm to 1.8v for it's rated speed/timings with stock cpu speed.

Afterburner · #2 07-07-2009

Quote:

Originally Posted by hellcamino

I'm still curious, my board with the Mushkin ram I first tried would set the vtt to 1.585v and vdimm to 1.8v for it's rated speed/timings with stock cpu speed.

OK... My VDimm is manually set @ 1.65 per factory specs.

What the heck is VTT? CPU? My CPU VTT is 1.325. I am a noob now... Still learning all this lingo stuff.

Also the Classy has WAY more settings than my x58 does, and I did not see it in there either....
Below are a few screen shots for a better idea of what some of the BIOS options are....

http://img186.imageshack.us/i/overclockingx58.pdf/

DrNip · #3 07-07-2009

I saw this coming and am still kicking myself for buying my Blades.

limpkorn · #4 07-07-2009

Wow, you planning to RMA before they choke Nip?

HITandRUN · #5 07-07-2009

Corsair rocks! I have the GTs and knock on wood its all good so far!

DrNip · #6 07-07-2009

My Classy and DFI set the VTT around 1.2v and DIMM around 1.56v.

hellcamino · #7 07-07-2009

Quote:

Originally Posted by DrNip

My Classy and DFI set the VTT around 1.2v and DIMM around 1.56v.

Was that for rated speed/timings for your ram?

DrNip · #8 07-08-2009

Quote:

Originally Posted by hellcamino

Was that for rated speed/timings for your ram?

By no means that was just the default BIOS settings.

hellcamino · #9 07-08-2009

Quote:

Originally Posted by DrNip

By no means that was just the default BIOS settings.

OK...I wasn't asking what your board auto set your ram at 400mhz...Rated speed and timings please. Unless of course you run your ram at 10-10-10-30 1T @ 400mhz....

hellcamino · #10 07-07-2009

Interesting that you and Nip were both running fairly low QPI/VTT assuming that the bios is fairly accurate. I tried to get mine down and it wasn't having it once i raised the cpu clock but my ram wouldn't pass memtest (when overclocked) unless I lowered the vdimm (ram voltage) to 1.6v. I've seen it where lower vdimm worked better but not lower then stock rated voltage before., again assuming that my bios is fairly accurate as I haven't measured actual values yet.