Project C - Page 5

Witchdoctor · #1 05-06-2010

Hey C sounds like the rad was not quite dead on balls

Hoping it is a simple enough fix

Go to hardware store buy a drill bit just a hair bigger than the holes .... prolly 1/16th bigger
drill through all 12 holes and try again ... that should get you so you can pull it tight

You will need a jig saw to fix the notch

take off end panle and the bottom cut extend 1/4" then on both sides of the notch

that should be just about it .... time to preform repair 15 minutes .....

I knew I should of had you ship me that rad ....

sorry for the screw up bro

Cecil · #2 05-07-2010

Quote:

Originally Posted by Witchdoctor

Hey C sounds like the rad was not quite dead on balls

Hoping it is a simple enough fix

Go to hardware store buy a drill bit just a hair bigger than the holes .... prolly 1/16th bigger
drill through all 12 holes and try again ... that should get you so you can pull it tight

You will need a jig saw to fix the notch

take off end panle and the bottom cut extend 1/4" then on both sides of the notch

that should be just about it .... time to preform repair 15 minutes .....

I knew I should of had you ship me that rad ....

sorry for the screw up bro

Its not a problem. Ill probably just leave it as is. I wanted some slack with the tubing anyway for when I stick the rad in a cooler, so having it mounted the other way will give more room for the tubing to loop around.

Witchdoctor · #3 05-07-2010

Pics bro when your 100% done

Keep it clean bro and dump the photo bucket

Cecil · #4 05-07-2010

Quote:

Originally Posted by Witchdoctor

Pics bro when your 100% done

Keep it clean bro and dump the photo bucket

I like it cause I only have to upload once to one place, then link to it. Im getting lazy

Darth Iudicium · #5 05-07-2010

Wow, really nice looking rack. Probably be my next step up from a case once I get things rolling along. Quite the Crafter.

Cecil · #6 05-10-2010

Finally got the loop flowing. Was having trouble with the inlet to the rad leaking, but I "think" I got it working now. Going to leak test over night, and hopefully get to benching again tomorrow.

Pics to follow soon.