[GeorgeStorm]

No, i just used -100 as an example.
Right, well, I tried a range of voltages to try and get something to work
As said above, but for the e2160, which I had a little more success with:
vCore 1.8-1.9
vNB 1.4-1.5
vFSB 1.4-1.5
vPLL 1.6-1.8
Temps started in the -90 range, then we accidentally went to -100, and it didn't crash etc, and booted up fine, so we kept it there, and then went to around -110, again, didn't seem to have too many issues, but based on the poor contact, I'm sure the cpu was far far hotter than that.
It just clocked bad Again which is why i reckon it wasn't that cold due to poor contact, as i said, apart from getting a slightly better cpu-z, my SS clocked both chips better, and thats only in the -30s

[GeorgeStorm]

Yeah, the e6300 wouldnt even do 430.
Got the e2160 to 480 yeah, can't remember if i tried higher, I think I did, but will give it another go tomorrow
PL was left on auto

[GeorgeStorm]

Another go today
Moved the probe, think the readings were more reliable.
Felt as though it went better today, even though I got no scores whatsoever, overall the system played ball more, think the contact was better.
Although had an e9 error code at the end, and when I dismantled, bit of ice on the bottom of the board around the edge of the backplates armaflex, don't think the board is dead though
Am gonna try the e4300 tomorrow and I guess I'll find out

[Hondacity]

water is the only problem for most.

vaseline cures the water virus...

[GeorgeStorm]

Well, had a much better session this afternoon, only 2 hours or so, but the e4300 seemed to do better, maybe cos I put a little less insulation around the cpu (thanks nat ), and got a hole drilled near the base so the temps were reporting correctly
Will post up the scores asap, and next time I'll take a camera

[Hondacity]

woooooooot

[GeorgeStorm]

Should i just put the scores here? Rather than make a new thread, cos I wouldn't know where to put the scores as it's not for OCA...

[OC Maximus]

Postem up.

OCM

[GeorgeStorm]

First I'd like to say thanks for all the help from you guys

Here's what I managed today with the e4300 (started with the e2160, gave up after half an hour with a meh mount)
cpu-z - 6th
http://hwbot.org/community/submission/1083094_

superpi - 9th
http://hwbot.org/community/submission/1083096_

pifast - 7th
http://hwbot.org/community/submission/1083108_

FSb wall at 500, and no scores tweaked due to time constraints, but I'm making progress

Now that I'm starting to get the hang of it, expect more

[Kal-EL]

Originally Posted by GeorgeStorm

First I'd like to say thanks for all the help from you guys

Here's what I managed today with the e4300 (started with the e2160, gave up after half an hour with a meh mount)
cpu-z - 6th
http://hwbot.org/community/submission/1083094_

superpi - 9th
http://hwbot.org/community/submission/1083096_

pifast - 7th
http://hwbot.org/community/submission/1083108_

FSb wall at 500, and no scores tweaked due to time constraints, but I'm making progress

Now that I'm starting to get the hang of it, expect more

Both eyes on you George