[limpkorn]

I've always had best overclocking results by leaving vdroop off.

Usually when you set Vdroop on you have to crank up more voltage in the bios.

[MaadDaawg]

I've always left it off on my Classified, but always had it turned on on my R2E .. possibly one of the reasons the R2E hasn't been a very good match with the 920 D0 I put on it

[2chesapeakes]

I use it on the classified, the R2E, and the RE but none of these boards are 24/7 use. I usually try and boot in with the minimum amount of volts set in bios and like the the extra boost there when I am benching. I have also noticed I could set less volts in bios and this non droop would kick in while windows was booting. I think it is an excellent feature of any board.