[ny_driver]

Originally Posted by DrNip

I had the same problem with my temp gauge except it stopped at -130. It was like trying to see in the dark and sucked. Ended up ruining my last session.

Watch the language bro, PG-13 forum here. I ninja edited your post for ya.

I ran the 1090T w/ LN2 the other day with no problems and the same thermometer. Now I can't get it to OC at all with 1 in the last slot.....gotta mess with it for awhile.

My bad, thanks.

EDIT: 1st slot works again EDIT: Dual Channel works too, then I poured a bunch of LN2 while in bios and it froze up and now acts same DRAM.

[ny_driver]

Every time I think I've got it straightened out it freezes up again. I don't know...either this 1090 , or my memory or who knows what. Guess I should try another CPU. It's all work now....yup now according to the board the cpu is bad....gonna pop the 965 in there.

EDIT: everything works fine with the 965.......what a waste of time and resources. I'm going to bed because I have a bad seat on the 965 because I was too lazy to warm the pot up and put good TIM in there when I switched cpus. I'll remount it in the morning and use up this juice....what I didn't waste. My eyes are beat and I'm already partially soured o the experience for now.

Happy New Years anyways. Tomorrow will be a better day at least with the 965. Wonder what the problem with the 1090T is....I've been using it.

[ny_driver]

Now it's mounted good and freezing up like CB or something.....hard to tell not knowing. I thought it was going well until I got it really cold. I thought these Thubans had no CB.

Deep breath............exhale......... EDIT: I think the memory is getting too cold and developing moisture. Sound possible?

[ny_driver]

Good news finally.......6.625GHz

The board is a little too frosty for my liking.............so doing some preventative maintenance and remount that 1090T.

btw...why do all my cpuz validations from today and half the time say "rejected by cpu-z" at the top? They sure as hell happened.