[MaadDaawg]

Finally got my fatboy insulated and mounted to the card It's sitting in the slot but I can't run it yet cause I can't find my vaseline

Ended up wrapping the entire pot with blue tape, then armalex (cut outs for the fittings etc), then a sheet of frost king all the way around too That did a pretty good job of eating up most of the gap but I erasered the fitting around the copper block then stuffed eraser into the sides and bottom and top after mounting the pot to the card.

Used 13 copper moffset blocks, 6 black aluminum chip sinks, and 7 low profile memory chip sinks.

Looks pretty bad ass As soon as I can find a black Sharpie so I can write MD on it I'll take a pic

added: I broke my favorite insulating tool right at the end my wooden chopstick snapped right in half dammit

[Splave]

in

!

[Witchdoctor]

LOL ...... No vaseline ???

sounds kinda Gay

[MaadDaawg]

Come on Doc, everyone knows gays use lubricant, not vaseline.... jeeez :

[Kal-EL]

Thx for sharing, thread is epicless without pics :(

[MaadDaawg]

Ok, you're right (I guess).

But only 1 until I get MD stenciled on the front

Besides, it's a little lonely up there by itself

PS. no shop towels yet either

[Splave]

thats is looking shmexy bro

[MaadDaawg]

Thanks Splave I'll look better once I find a black marker to put the MD on the exposed frost king Off to the store today to buy some more vaseline and shop towels... then... ready to fire her up

Here's a shot with her companion in crime

PS. I've noticed many of you have removed your RAM fans, I suspect that's because they have a tendency to pull vapors down onto the ram, and thus exposing the unused slots to possible condensate. I've taped over the empty slots and put eraser over the tape and against each side of the Ram sinks, so I'm thinkin I'll be ok ???

One of these days I'll try my RAM Pot by KP, but not this time

[MaadDaawg]

Vaseline in hand... soon to be in slot.

New shop towel supply in house

countdown to begin soon

[Kal-EL]

Git er dun, start a new thread on your progress and post up them benchies