Onward and upward.
Picture of the preparation of the side panel for the custom print!
tools needed, squeege, felt squeege for after decal is installed so as to not scratch it after the pre-mask is removed, knife, new blades, and spray bottle.
the print before application:
and the side panel after installation:
then the panel installed on the computer!
Here in the front panel, we see the fan controller and underneath the three switches that control the cold cathodes, and the strobes!
then some inside shots, both graphics cards installed, and the other part of the print matching mounted to the inside of the back panel, to bring the "COSMIC" effect into the case, going along with the matching black hardware, and metallic black paint on the inside of the case!
Notice how the small prints mounted on the graphics cards match the main print too!
Next posts will be tomorrow, some full exterior and interior shots, another little mod to the inside, to highlight the print on the graphics cards, and hopefully some movies highlighting the overall lighting effects!
Enjoy for now!
acebook
Threaded Mode