[Hondacity]

pics or its not true! its a joke..but yeah i'ld appreciate a photo of your setup

in reality the ddr3 for x58/p55 don't heat up so much...yes you can use the pot just on top their heat spreaders but not efficient and if you're pushing for 1.8-1.9v i prefer clamped down rams..

[Jor-El]

Originally Posted by Hondacity

pics or its not true! its a joke..but yeah i'ld appreciate a photo of your setup

in reality the ddr3 for x58/p55 don't heat up so much...yes you can use the pot just on top their heat spreaders but not efficient and if you're pushing for 1.8-1.9v i prefer clamped down rams..

If you insulate using armaflex right and leave just the exact space (two thin strips) to fit above the ram it freezes down nicely.

Got all frosty till the ram slots got white and thick.

[MaadDaawg]

I was actually thinking of building up a block wall of eraser all around each stick, then insulating the pot with armaflex and/or frost king except for the 3 stripes where it will sit on top of the ram coolers.

Did you find any noticeable difference using the LN2 on your ram Jor ??

[Jor-El]

Originally Posted by MaadDaawg

I was actually thinking of building up a block wall of eraser all around each stick, then insulating the pot with armaflex and/or frost king except for the 3 stripes where it will sit on top of the ram coolers.

Did you find any noticeable difference using the LN2 on your ram Jor ??

Yes your are on the money MadDog that's how I did it. I would just ad a little of dielectric grease on the ram pins (to be safe) you don't need much here, a little is a little.

You will gain some extra mhz needed to beat Nicksith for gold cups, but if you're aiming for less the difference is not that big.